LIVINGSTON COUNTY, Ky. (2/8/13) – A contractor for the Kentucky Transportation Cabinet plans to place a lane, load width, and weight restriction on the US 62/US 641 Cumberland River Bridge at Lake City in Livingston County starting Wednesday, February 13, 2013.
This lane and load restriction is to allow retrofitting of floor beams on the bridge structure.
The US 62/US 641Cumberland River Bridge is at the Livingston-Lyon County Line immediately below Barkley Dam at Lake City, KY. Also, known as The Blue Bridge and the Eureka Highway Bridge, the structure carries approximately 7,000 vehicles in an average day.
Traffic will be restricted to one lane and a strictly enforced 12-ton load limit during the work. There will be a10 ft. load width restriction in this work zone.
This lane restriction with alternating traffic flow controlled by an automated signal will be in place around the clock. An enhanced enforcement presence has been requested for this work zone.
Due to the potential for traffic delays during peak travel periods, motorists are advised to self-detour via Interstate 24. The minimum delay is estimated at about 5 to 10 minutes during the morning and afternoon commute.
Intech Contracting LLC, is the prime contractor on this $247,051 bridge maintenance project. This work zone with lane, load width, and strictly enforced 12 ton maximum load limit will be in place for about 5 weeks, weather permitting.
The 1,466 ft. cantilevered Warren through truss bridge with a 700 ft. main span was opened to traffic in 1952. The bridge is at US 62 Livingston County mile point 2.852 and Lyon County mile point 0.0.
Timely traffic advisories for the 12 counties of KYTC Highway District 1 are available by going to www.facebook.com/kytcdistrict1. You do not have to be a Facebook member to access this page.
Information provided by Keith Todd
Photo provided by SurfKY Graphics
Copyright 2013 SurfKY News Group, Inc. All rights reserved. This material may not be published, broadcast, rewritten, or redistributed.
|< Prev||Next >|